Swing louvre movement
A damaged gear or obstructed louvre can click repeatedly as the motor tries to travel. Forcing a flap by hand may break the mechanism further. We check the programmed movement and physical alignment before replacing parts.
Occasional expansion sounds can occur as panels warm or cool, but repeated loud tapping, scraping or clicking alongside poor airflow may indicate a fan, louvre or electrical-control problem.
The timing matters: a sound only during louvre travel suggests a different diagnostic route from clicking at the outdoor contactor or a scrape that follows fan speed.

We assess the indoor fan, louvre travel, visible casing alignment and control response without exposing live electrical parts. If the outdoor section is involved, it receives a separate safe inspection.
A damaged gear or obstructed louvre can click repeatedly as the motor tries to travel. Forcing a flap by hand may break the mechanism further. We check the programmed movement and physical alignment before replacing parts.
A scrape or ticking sound that changes with fan speed can point to the blower wheel, dirt buildup or contact with the casing. The internal fan should be isolated and inspected by a technician, not probed through the outlet while running.
Some switching clicks may be normal, but sustained chattering or repeated failed starts should be investigated. The pattern must be interpreted alongside supply and equipment behaviour, not diagnosed from sound in isolation.
When a clicking sound follows the swing command, the louvre drive becomes a stronger candidate than a compressor problem. Tapping that persists with swing disabled but tracks blower speed points elsewhere. Neither pattern justifies pushing a jammed flap by hand or continuing to operate a fan that appears to scrape the casing.
The repair might be a damaged louvre linkage, loose panel, fan component or control fault. We avoid fitting parts on sound alone until the behaviour is reproduced safely.
Tell us whether the noise occurs when changing swing mode, fan speed or temperature. A recording can help, but do not insert anything through an operating outlet.
After service, test the normal range of louvre and fan modes; report any returning mechanical scrape instead of forcing a stuck flap.
Avoid manually forcing a stuck outlet flap or inserting objects through the louvers; disengage the system for a recurring mechanical scraping sound.
Yes. Describe the sequence, error indications and system type when booking. The inspection determines whether the trouble is with settings, airflow, electrical controls or cooling equipment before a repair is recommended.
Appointment availability depends on the address, technician schedule and access to the equipment. We confirm the visit after reviewing your enquiry; the site does not promise a specific arrival time.
Not automatically. Poor cooling has several causes, and a sealed circuit should not need routine refrigerant topping up. A suspected loss needs appropriate leak investigation by qualified personnel.
The indoor unit brand or model, approximate age, symptoms, displayed fault code and safe access arrangements are useful. Describe what happens first rather than guessing which part has failed.
Tell us whether the noise occurs when changing swing mode, fan speed or temperature. A recording can help, but do not insert anything through an operating outlet. You can use the online request or message the same details on WhatsApp.